How To Light Pilot Light On Superior Gas Fireplace. When the fireplace or propane heater is turned on, the pilot light serves as an ignition source for the larger sweep of gas released from the burner. Push the igniter button once every second until it lights.
After lighting gas logs pilot light, set. The pilot position is typically set on the control dial with either the dial depressed and turned, or used with a separate spark button to light the pilot flame. Locate the valve on your fireplace and turn it clockwise.
If The Pilot Does Not Light, Wait 5 Minutes And Try Again.
Ensure the gas is turned on to allow gas to the fireplace. With your hand still pressing the control knob, wait about five seconds before pressing and repeatedly releasing the igniter. Once the pilot is lit, you can leave the fireplace pilot on and turn the fireplace on and off at the switch, remote or other application.
After Lighting Gas Logs Pilot Light, Set.
It shows that there is the slightest amount of gas running to the unit at all times. When the fireplace or propane heater is turned on, the pilot light serves as an ignition source for the larger sweep of gas released from the burner. Read and follow the instructions that came with you.
When The Pilot Light On A Gas Fireplace Doesn’t Ignite, You Won’t Get Any Flames.
Push in the pilot knob, which will then manually send gas into the system. This fireplace has a pilot which must be lit manually. Ensure the gas is turned on to allow gas to the fireplace.
These Should Be Toward The Bottom Of The Unit And.
The ignitor could be functioning, but the unit is not getting fuel. Lighting the pilot on a gas fireplace.for your safety, read before lighting:a. Most gas fireplaces have a standing pilot light, which is a small flame that burns even when you aren't using the fireplace.
Push The Igniter Button Once Every Second Until It Lights.
Sometimes, pilot lights are impacted by a strong draft in the chimney. Turn the safety control valve knob to the pilot position. Lighting a superior gas fireplace press in on the control knob and move it from 'off' to the 'pilot' position.