close
close

How To Set Honeywell Thermostat For Heat

th 1614

How To Set Honeywell Thermostat For Heat. Touch menu on the thermostat display, select schedule. To change your settings, press the “ system ” button again.

Honeywell FocusPro Programmable Thermostat (1 heat/1 cool
Honeywell FocusPro Programmable Thermostat (1 heat/1 cool from clecomarketplace.com

How do i set the temperature on my honeywell non programmable thermostat? Touch select to edit each period. By switching on your honeywell thermostat’s em heat, you’re simply commanding your system to switch off the primary heat mode and rely only on the auxiliary mode.

How Do I Set The Temperature On My Honeywell Non Programmable Thermostat?

Check the thermostat is set to heat, and see if the heat on button is blinking. The system should start blowing hot air. Make sure the thermostat is configured correctly for the heating/cooling system type.

Touch The Menu Tab On Your Programmable Thermostat, Then Hit Schedule.

To change your settings, press the “ system ” button again. Your pump will now either run solely on the electric heat strip or the backup gas furnace. The heating system should stop blowing hot air.

Wait While The Heating Or Cooling Works To Achieve The Temporary Temperature Setting.

If you are trying to set the heat and cool set points for your program settings (wake, leave, return, sleep) the thermostat allows you to adjust each set point as you cycle through the program settings. Adjust the thermostat dial until the setting exceeds room temperature; Verify the wiring is connected correctly and securely to the thermostat.

Honeywell's Programmable Thermostat Will Keep You Warm From 9To5Toys.com.

Touch the up or down arrows on the right side of the display to increase or decrease the target temperature. Evenly distribute the temperature in your house and improve your insulation can help to prevent an auxiliary heat backup. Once you decide to return to your programmed setting, press the run tab, and that will cancel the override.

Verify That The Thermostat Is Set To Heat And Is Calling For Heat, Usually Indicated By The Words “Heat On, A Flame Icon, Or A Shimmering Sun Icon.

To change the setting, push the button again. Set the temperature between 60 and 80 degrees fahrenheit to keep the house at a consistent temperature and avoid using auxiliary heat. By switching on your honeywell thermostat’s em heat, you’re simply commanding your system to switch off the primary heat mode and rely only on the auxiliary mode.

Leave a Reply

Your email address will not be published.